![The IC-485S is hardware solutions to the problem of converting signals between two standards. Data transfer can take place at up to 1200m (4000'), over four or two wire cable for full or half duplex, respectively. The converters can handle any RS-485/RS-422 device allowing it to function as a short haul modem or interface converter. Request to send (RTS) selection allows up to 32 receivers to be set up in a multidrop installation, making for a cost effective network configuration. The IC-485S is a bi-directional interface converters for RS-232 and RS-485. With the IC-485 series, it provides Point-to-Point, Multidrop and Simplex operations. The IC-485S also provides an extra Monitoring function. Two slide switches are used to configure its operation mode, contention control, and assignment of the RS-232. Data Transmission Controlled by the RTS Signal DCE/DTE Selcetable Point to Point, Multidrop, and Simplex/Duplex Link Selectable Four Wire Full Duplex / Two Wire Half Duplex Monitor configuration Support Compact Size Connectors RS-232 DB-25 Female RS-485 / RS-422 Four Terminal Block RJ-11 Switches SW1: DCE, DTE, Monitor, TxON, RxON SW2: T-RTS, R-RTS, T-RTS, RxON Data Rate Up to 100 Kbps Under 1200m [4000'] Cable Length 1200 m [4000'] (Max.) Power Consumption DC 9V 150mA (Max.) Housing Plastic Weight 2.116 lbs Dimensions Length: 2.933 inch Width: 2.126 inch Height: 0.728 inch](http://media.compusa.com/prodimages/19/da6f23af-a902-4cbf-bd8d-34f926b0c705.gif)
Bidirectional Converter, IC-485S RS-232 to RS-485/RS-422 - Accessories, Cables, Connectors/Adapters
The IC-485S is hardware solutions to the problem of converting signals between two standards. Data transfer can take place at up to 1200m (4000'), over four or two wire cable for full or half duplex, respectively. The converters can handle any RS-485/RS-422 device allowing it to function as a short haul modem or interface converter. Request to send (RTS) selection allows up to 32 receivers to be set up in a multidrop installation, making for a cost effective network configuration. The IC-485S is a bi-directional interface converters for RS-232 and RS-485. With the IC-485 series, it provides Point-to-Point, Multidrop and Simplex operations. The IC-485S also provides an extra Monitoring function. Two slide switches are used to configure its operation mode, contention control, and assignment of the RS-232. Data Transmission Controlled by the RTS Signal DCE/DTE Selcetable Point to Point, Multidrop, and Simplex/Duplex Link Selectable Four Wire Full Duplex / Two Wire Half Duplex Monitor configuration Support Compact Size Connectors RS-232 DB-25 Female RS-485 / RS-422 Four Terminal Block RJ-11 Switches SW1: DCE, DTE, Monitor, TxON, RxON SW2: T-RTS, R-RTS, T-RTS, RxON Data Rate Up to 100 Kbps Under 1200m [4000'] Cable Length 1200 m [4000'] (Max.) Power Consumption DC 9V 150mA (Max.) Housing Plastic Weight 2.116 lbs Dimensions Length: 2.933 inch Width: 2.126 inch Height: 0.728 inch
50123112 - ATEN Technology - IC485S